Hitachi S1 Series Basic Manual page 45

S1 series standard inverter
The running command channel can be set by terminal commands besides P00.01.
Current running
command channel
P00.01
Keypad
Terminal
Communication
Note: "/" means this multi-function terminal is valid under current reference channel.
Related parameter list:
Function
code
P00.00 Speed control mode
Running command
P00.01
P00.02
Motor parameter
P00.15
Function parameter
P00.18
Multi-function terminal
function (36)
Command switches to
keypad
/
Keypad
Keypad
Name
1: SVC 1
2: V/F
Note: If 1 is selected, it is required to
carry out motor parameter autotuning
first.
0: Keypad
1: Terminal
channel
2: Communication
Reserved Reserved
0: No operation
1: Rotary autotuning; carry out
comprehensive motor parameter autotuning;
rotary autotuning is used in cases where high
control precision is required;
2: Static autotuning 1 (comprehensive
autotuning); static autotuning 1 is used in
autotuning cases where the motor cannot be
disconnected from load;
3: Static autotuning 2 (partial autotuning) ;
when current motor is motor 1, only P02.06,
P02.07 and P02.08 will be autotuned; when
current motor is motor 2, only P12.06,
P12.07 and P12.08 will be autotuned.
0: No operation
1: Restore to default value
restoration 2: Clear fault history
Note: After the selected function
Multi-function terminal
function (37)
Command switches to
terminal
Terminal
/
Terminal
Detailed parameter description
-40-
Multi-function terminal
function (38)
Command switches to
communication
Communication
Communication
/
Default
value
2
1
0
0
0