Hitachi S1 Series Basic Manual page 140

S1 series standard inverter
Function
Name
code
terminal control
setup
UP terminal
frequency
P08.45
incremental
integral rate
DOWN terminal
frequency
P08.46
decremental
change rate
Action selection
for frequency
P08.47
setup during
power down
High bit of initial
P08.48 value of power
consumption
Low bit of initial
P08.49
value of power
Detailed parameter description
Ones: Frequency control selection
0: UP/DOWN terminal setup is valid
1: UP/DOWN terminal setup is invalid
Tens: Frequency control selection
0: Valid only when P00.06=0 or P00.07=0
1: All frequency modes are valid
2: Invalid for multi-step speed when multi-step
speed takes priority
Hundreds: Action selection during stop
0: Valid
1: Valid during running, clear after stop
2: Valid during running, clear after receiving stop
command
0.01–50.00Hz/s
0.01–50.00Hz/s
0x000–0x111
Ones: Action selection for frequency setup (by
keypad digits) during power down
0: Save during power down
1: Zero out during power down
Tens: Action selection for frequency setup (by
Modbus) during power down
0: Save during power down
1: Zero out during power down
Hundreds: Action selection for frequency setup
(by other communication) during power down
0: Save during power down
1: Zero out during power down
Set the initial value of power consumption.
Initial value
consumption=P08.48×1000+ P08.49
Setting range of P08.48: 0–59999 kWh (k)
Setting range of P08.49: 0.0–999.9 kWh
-135-
Default
0.50Hz/s
0.50Hz/s
of power
Modify
value
○
○
○
0x000
○
0°
○
0.0°