Hitachi S1 Series Basic Manual page 132

S1 series standard inverter
Function
Name
code
Displayed
P07.06 parameters 2 of
running state
The parameter
P07.07 selection of the
stop state
Frequency
P07.08
display coefficient
Speed display
P07.09
coefficient
Linear speed
P07.10
display coefficient
Temperature of
P07.11 rectifier bridge
module
Temperature of
P07.12
inverter module
Software version
P07.13
of control board
P07.14 Accumulated
Detailed parameter description
BIT12: torque set value (% on)
BIT13: pulse counter value
BIT14: reserved
BIT15: current step of multi-step speed
0x0000 – 0xFFFF
BIT0: analog AI1 value (V on)
BIT1: analog AI2 value (V on)
BIT2: analog AI3 value (V on)
BIT3: high speed pulse HDI frequency
BIT4: motor overload percentage (% on)
BIT5: the inverter overload percentage (% on)
BIT6: ramp frequency given value (Hz on)
BIT7: linear speed
BIT8: AC inlet current (A on)
BIT9 – 15: reserved
0x0000 – 0xFFFF
BIT0: set frequency (Hz on, frequency flickering
slowly)
BIT1: bus voltage (V on)
BIT2: input terminals state
BIT3: output terminals state
BIT4: PID reference (% flickering)
BIT5: PID feedback value (% flickering)
BIT6: torque reference (% flickering)
BIT7: analog AI1 value (V on)
BIT8: analog AI2 value (V on)
BIT9: analog AI3 value (V on)
BIT10: high speed pulse HDI frequency
BIT11: current step of multi-step speed
BIT12: pulse counters
BIT13 – BIT15: reserved
0.01–10.00
Display frequency=running frequency× P07.08
0.1–999.9%
Mechanical speed=120×display running
frequency×P07.09/number of motor pole pairs
0.1–999.9%
Linear speed=mechanical speed×P07.10
-20.0–120.0° C
-20.0–120.0° C
1.00–655.35
0–65535h
-127-
Default
Modify
value
0x0000
○
0x00FF
○
1.00
○
100.0%
○
1.0%
●
/
●
/
●
/
●
/