Envelopes - Konica Minolta magicolor 3730DN User Manual

Driver
Media Type
Weight
Duplexing

Envelopes

Print on the front (side where the recipient's address is written) side only.
Some parts of the envelope consist of three layers of paper—the front, back,
and flap. Anything printed in these layered regions may be lost or faded.
You can print continuously with envelopes. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Capacity
Orientation Face down
Driver
Media Type
Duplexing
Use envelopes that are
Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
Approved for laser printing
Dry
DO NOT use envelopes that have
Sticky flaps
Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal-
ing
Transparent windows
Too rough of a surface
Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
Been presealed
4-6
Thick 1 (91–150 g/m
Thick 2 (151–210 g/m
91–210 g/m²
See page 100 for supported sizes
Tray 1
(Manual Feed
Tray)
Tray 2
Envelope
Not supported
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
2
)
2
)
1 envelope.
Not supported
Media Types