Konica Minolta magicolor 3730DN User Manual page 140

Symptom
Printing
takes too
much time.
Blank pages
come out
during print-
ing.
The machine
does not
enter Energy
Saver mode.
Paper
cannot be
loaded into
Tray 1.
Solving Other Problems
Cause
The printer is set to a
slow printing mode
(for example thick
stock).
The printer is set to
Energy Saver mode.
The job is very com-
plex.
A toner cartridge for a
different region or an
unapproved genuine
toner cartridge is
installed (
INCOR-
RECT X T/C
is displayed in the
message window).
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
Paper has been
loaded into Tray 1.
The machine has
entered Energy
Saver mode.
Solution
It takes more time to print on special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
Energy Saver mode. If you do not want
to use this mode, contact Technical
Support.
Wait. No action needed.
Install a correct KONICA MINOLTA
toner cartridge approved for your spe-
cific printer.
Check the toner cartridges. The image
will not print if one or more cartridges
are empty.
Check that the media type set in the
driver matches the media loaded in the
printer.
Remove all paper from Tray 1.
After the machine is ready for opera-
tion, load paper into Tray 1.
7-25