Symptom
Media is
wrinkled.
The pages
that were fed
out were not
uniformly
loaded.
7-28
Cause
The media is moist
from humidity or hav-
ing water spilled on it.
The transfer roller or
fuser unit is defective.
Unsupported media
(wrong size, thick-
ness, type, etc.) is
being used.
There are large curls
in the paper.
There are gaps
between the media
guides of the paper
tray and the sides of
the paper.
Solution
Remove the moist media and replace it
with new, dry media.
Check them for damage. If necessary,
contact Technical Support with the
error information.
Use KONICA MINOLTA-approved
media. See "Media Specifications" on
page 4-2.
Remove the paper from the paper tray,
turn it over, and then load it again.
Slide the media guides of the paper
tray against the sides of the paper so
that there are no gaps.
Solving Other Problems