Replacing The Streamer Unit - Daikin STREMER MC40UVM6 Operation Manual

Table of Contents

Advertisement

Maintenance
Maintenance

Replacing the Streamer Unit

1.
Remove the pre-fi lter on the left side from the
back of the unit.
2.
Flip up the protective covers and remove the
streamer unit cover.
Place your fi nger on the hook
and pull it towards you.
3.
Remove the streamer unit.
1 Remove the streamer unit connector.
2 Push in the left side of the streamer unit so the right
side comes out.
3 Remove the streamer unit.
15
If the streamer lamp blinks
The streamer unit will not need to be replaced. However, depending on where the unit is used
(places where oils are present, or dust and humidity is abundant, or sprays and chemical agents
are used, etc.) replacement may become necessary.
Contact the place of purchase.
►Page 13
Protective
Streamer unit cover
covers
Hook
Viewed from rear
1. Push the hook on the connector
2. Pull it out while pushing the hook
The lock will not release unless
the hook is pushed
(Pulling forcibly may cause damage)
Connector
Hook
2
1
You will hear a
catching sound.
WARNING
Before cleaning and maintenance work, make sure to
unplug the unit. (An electric shock or injury may result)
►Page 17
4.
Attach the new streamer unit.
1 Insert the streamer unit from the left side, and push
until the hook makes a catching sound.
2 Make sure the hook is facing to the right, and insert
the connector as deeply as it will go.
5.
Attach the streamer unit cover.
Hook
Secure the hooks (2 locations)
on the left side of the streamer
unit cover
• Ensure you don't trap the connector cord.
• If the streamer unit cover is not properly attached the
safety switch will engage, and the unit cannot operate.
6.
Attach the pre-fi lter.
7.
Insert the power supply plug while pressing
on the unit, and wait until a short beep
sounds.
• The streamer lamp will turn off.
• If you release
and attempt operation before the
short beep sounds, the streamer lamp will blink again.
• If you perform this step and the streamer lamp still blinks,
please check that the connector is properly inserted.
Catching sound
Push until you
hear a catching
sound
►Page 13

Advertisement

Table of Contents
loading

Table of Contents