Table of Contents
Advertisement
WARNING! TO REDUCE THE POTENTIAL FOR PERSONAL INJURY AND/OR
DAMAGE TO THE MACHINE, BEFORE ASSEMBLING MAKE SURE THE
MACHINE IS TURNED OFF AND THE PLUG IS NOT CONNECTED TO A
POWER SOURCE. DO NOT TURN ON OR PLUG IN THE MACHINE UNTIL
INSTRUCTED TO DO SO AFTER ALL ASSEMBLY STEPS IN THIS MANUAL
HAVE BEEN COMPLETED.
Assembling the fence
1) Attach the fence support arm (A) Fig.4 to the rear of the cabinet (B) using 4
round head allen screws (C).
2) Fit two round head allen screws through the holes in the fence mounting
bracket (A) Fig.5 and loosely thread a square nut (B) onto the end of each
round head allen screw.
3) Slide the t-slot in the rear of the fence (C) onto the square nuts (B).
4) Center the fence (C) on the mounting bracket (A) and secure it by tightening
the 2 round head allen screws.
5) Sit the fence bracket (A) Fig.6 on the support arm (B). Slip the threaded end of
the fence lock handle (C), with flat washer (D), through the bracket and support
arm. Thread a square nut (E), flat end up, onto the threaded end of the lock
handle and tighten the lock handle to secure the fence assembly to the support
arm.
Attach the dust chute
1) Loosen the four screws (A) Fig.7, position and secure the dust chute assembly
(B) to the cabinet under the outfeed table as shown using the same four
screws. Insert the 2-1/2" dust port fitting (C) into opening as shown if required.
Note: The 2 1/2" and 4" dust port adaptor allows you to connect the machine to
your shop dust collection system (not included). Be sure to use correct size hoses
and fittings (not included). If you do not already own a dust collection system,
contact your King Canada retailer or visit our website at www.kingcanada.com for
information on our complete line of dust collectors and accessories.
ASSEMBLY
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
Advertisement
Table of Contents
