Table of Contents
Advertisement
1.4.1.1.
Enabling the interface's video inputs (dip 2-3)
Only by dip switches enabled video inputs can be accessed by switching through the
interface's video sources. It is recommended to enable only the required inputs. Disabled
inputs will be skipped while switching through the video interfaces inputs.
1.4.1.2.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.1.3.
Monitor selection (Dip 6-8)
Dips 6-8 customize the monitor-specific video settings.
Note: Dip 4 is out of function and has to be set to OFF!
1.5.
Settings of the 4 Dip switches (CAN functions – red)
Dip position down is ON and position up is OFF.
Vehicle/Navigation
All vehicles
After each Dip-switch-change a power-reset of the Can-box has to be performed!
2. Installation
To install the interface, first switch off the ignition and disconnect the vehicle's battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation
The interface is supposed to be installed at a suitable location behind the vehicle`s head-
unit.
Version 24.07.2018
Dip 1
Dip 2
Dip 3
OFF
ON
OFF
CAM(V97)/(V30)
Dip 4
OFF
CI-RL3-MIB92
Advertisement
Table of Contents
