Renesas IECUBE2 User Manual page 18

QB-V850E2
(3) Status LED
The status LEDs turn on or blink according to specific causes as described in the table below. If any
LED does not turn on, IECUBE2 might be broken. In this case, contact a RENESAS Electronics sales
representative or distributor.
LED name
SYSTEM
POD
TARGET
(4) POD cable
This coaxial cable is used to connect the IECUBE2 main unit and emulation POD. The cable length is
shown below. Be careful not to excessively bend this cable because doing so might break the cable.
(5) Power connector
This connector is for the power supply cable.
(6) Power switch
This switch turns the power on and off. Press the "|" side to turn on the power or the "O" side to turn off
the power.
(7) USB connector
This connector is for a USB cable.
(8) Cooling fan
This fan cools down the IECUBE2 internal units. Be careful not to obstruct the vents.
R20UT0824EJ0101 Rev.1.01
2013.01.08
This LED turns on when the power switch is turned on.
This LED blinks if the FPGA in IECUBE2 is not running correctly. In this case,
IECUBE2 might be broken.
This LED turns on when communication with the emulation POD is established.
This LED turns on when the target system is turned on.
37cm
2.NAMES AND FUNCTIONS HARDWARE
Description
Page 18 of 26