Default Settings With Tv Out Enabled; Default Settings With Multimedia Enabled; Table 7: Dkhiqv-Agp Jumper Configuration Settings For Tv Out Enabled; Table 8: Dkhiqv-Agp Jumper Configuration Settings For Multimedia Enabled - Intel CHIPS DKHiQV-AGP User Manual

5.4.2

Default Settings with TV Out Enabled

Table 7: DKHiQV-AGP Jumper Configuration Settings for TV Out Enabled

Jumper NTSC Function*
W2 sh.5 TV OUT
W4 sh.5 TV OUT
W5 sh.2, TV OUT disable CRT
W6 sh.5 TV OUT, NTSC
W8 sh.2, TV OUT, TSYNC
JP1 sh.5 TV OUT
JP2 sh.5 TV OUT
JP3 sh.5 TV OUT
JP13 sh.2, CYSYNC/HSYNC
Notes: *Schematic reference and functional category.
**'on' - jumper plug installed.
'off' - jumper plug is not installed.
1. For PAL, U1/U4 on DKHiQV-AGP DK board must be replaced with a 17.7344 MHz crystal oscillator.
2. Using BMP utility, change RAM BIOS to NTSC/PAL on
XRE1[5]=1 (NTSC)
XRE1[6]=1 (PAL)
5.4.3

Default Settings with Multimedia Enabled

Table 8: DKHiQV-AGP Jumper Configuration Settings for Multimedia Enabled

Jumper
JP5
JP6
JP7
JP8
JP9
JP10
JP11
JP12
*Schematic reference and functional category.
Notes:
**'on' - jumper plug installed.
'off' - jumper plug is not installed.
&+,36
®
DKHiQV-AGP (Fab. Rev. A) Subject to Change Without Notice
DKHiQV-AGP (Fab. Rev. A) User's Guide
State** Jumper
off W2
2-3 W4
off W5
off W6
off W8
on JP1
on JP2
on JP3
on JP13
Function*
sh.2, I2C
sh.2, I2C
sh.2, DDC
sh.2, DDC
sh.2 GPIO
sh.2 GPIO
sh.2 GPIO
sh.2 GPIO
PAL Function*
sh.5 TV OUT
sh.5 TV OUT
sh.2, TV OUT disable CRT
sh.5 TV OUT, NTSC
sh.2, TV OUT, TSYNC
sh.5 TV OUT
sh.5 TV OUT
sh.5 TV OUT
sh.2, CYSYNC/HSYNC
State**
1-2, 3-4
all off
1-2, 3-4
all off
2-3
1-4
1-4, 2-3
off
Revision 1.0 7/13/98
20
State**
off
1-2
off
on
off
on
on
on
on