NAPCO GEMINI GEM-P1632 Programming Instructions Manual page 48

Page 48
To program, follow the 5 steps below:
To program, follow the 5 steps below:
STEP 1: RELAY # OPTIONS:
from Relay Module RM3008. Multiple events may be "mapped" to each relay,
up to a maximum of 16 events.
Select the relay number from Table 1 (shown on next page); enter in
corresponding right digit address location (left digit is not used).
STEP 2: AREA OPTIONS:
Area 2.
Select the area from Table 2 (shown on next page); enter in corresponding right digit address
location (left digit is not used).
STEP 3: TIMEOUTS:
Each relay event can be assigned a timeout depending on Alarm Type option.
If Alarm Type (see next page) is selected for timeout in minutes or seconds, select the timeout from Table
3 (shown on next page) in minutes or seconds and enter in corresponding address location (left digit and
right digits). To choose seconds or minutes, see step 5A below. 254 is maximum entry.
STEP 4: EVENT ID CODES:
Select 2-digit Event ID from Table 4 (see next page); enter in corresponding address locations (left and right digit).
STEP 5: RELAY EVENT CONDITION OPTIONS:
condition; also, select a timeout type for each.
5A. Select Alarm Type and Timeout Type from Table 5A (shown on next page); enter in corresponding address location (left
digit).
5B. Select Activation from from Table 5B (shown on next page); enter in corresponding address location (right digit).
X
GEM-P1632 Programming Instructions
The GEM-P1632 supports 8 external relays
Each relay event can be assigned to Area 1, Area 2 or both Area 1 &
Each relay event can be assigned any of the available event IDs from the table.
Each relay event can be assigned an alarm type; and an activation
WI1148B 10/06
RELAY EVENT OPTIONS
RELAY # AREA Timeout Event ID
L R L R L R L
(•) (•)
Step
Step Step Step
4
1 2 3
L
NAPCO Security Systems
COND.
R L R
Step
5
Continued