Table of Contents
Advertisement
As an option to turn on and off the Alum pump, install a flow switch. No electrical wiring to do and any
plumber, or person familiar with basic plumbing, can install it.
Simply plumb the pre-wired flow switch into your service pipe. Plug the flow switch into a standard 120V
wall outlet.
Then, plug the Alum pump into the electrical outlet on the flow switch. Whenever there is flow, the
metering pump will then turn on.
J-PRO-22
Instructions
While you can mount
above the solution
advised to mount the
J-PRO-22 Alum Guide Rev 0021622 Page | 7
Installation
the pump on a shelf
tank, it is strongly
pump directly on top
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the J-PRO-22 Alum and is the answer not in the manual?