Use Pre-Wired Flow Switch Option - Clean Water Systems J-PRO-22 Alum Installation & Start?Up Manual

Hide thumbs Also See for J-PRO-22 Alum:
Table of Contents

Advertisement

You may cut off the 110-style plug and wire a 220-style plug, and then plug that into a
dedicated 220- style wall outlet.
Install a dedicated wall outlet that is wired to the pressure switch and powered up
whenever the well pump turns on.
The J-Pro-22 is a dual voltage pump. It has a 110 volt- style plug but can run on 220v or
110v. It uses a maximum of 22 watts power when running.

Use Pre-Wired Flow Switch Option

J-PRO-22 Alum Guide Rev 0021622 Page | 6

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the J-PRO-22 Alum and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents