ProLights EclSoft LinearIP User Manual page 19

USER
SETTINGS
TRANSFER CON-
FIGURATION
3 CALIBRATION
AD-
VANCED
DIMMER
CURVE
DIMMER
SPEED
DIMMER
END
LED
FREQUENCY
DMX FAULT
INVERT
MAPPING
FAN MODE
TUNGSTEN
EMULATION
KEY LOCK ON
OFF
DISPLAY VALUE RAW DATA
PERCENTAGE
TEMPERATURE
°C
UNIT
°F
PRESET 1 TO 5 RECALL
SAVE
MOVE
SET AS DEFAULT
WITHOUT DMX
ADDRESS
WITH DMX
ADDRESS
ON
OFF
LINEAR
S-CURVE
SQUARE LAW
INVERSE SQUARE
LAW
HIGH RES@LOW
AUTO
FAST
MEDIUM
SLOW
FADE OFF@END
SNAP OFF@END
600Hz
1200Hz
2000Hz
4000Hz
6000Hz
10kHz
12kHz
15kHz
20kHz
25kHz
36kHz
40kHz
HOLD
BLACKOUT
STAND ALONE
EMERGENCY
ON
OFF
AUTO / HIGH /
CONSTANT
SILENT 1 / SILENT
OUTPUT
2 / OFF
AUTO / HIGH /
DYNAMIC OUTPUT SILENT 1 / SILENT
2 / OFF
OFF
AUTO
FAST
PROLIGHTS - EclSoft LinearIP
Lock the buttons on the con-
trol panel by a password.
Press following combinations
(password) in order to ac-
cess to the user menu : UP,
DOWN, UP, DOWN, ENTER.
Choose how to show datas
on Stand Alone Modes.
In percentage mode values
will be shown as 0-100%.
In Raw Data mode values
will be shown as 0-255.
Allows you to choose Tem-
perature unit showed in
home screen.
To transfer the same menu
settings of one fixtures to
all the other in the daisy
chain, including or not the
dmx address.
Enable/Disable Spektra
Calibration
Choose dimmer curve.
Set Dimmer Speed.
This parameter defines in-
terpolation of DMX
Changes for main functions.
Off turns off interpolation
Set Dimmer End behaviour.
Snap Off will make fixture
snap when dimming out to 0.
Fade Off will make fixture
fade when dimming out to 0.
This selection affects only
004-000 DMX value be-
haviour.
Select PWM frequency.
Select the product Fan mode
for Standard mode.
Constant Output: fixture will
decrease immediatly light
output. Note: fixture will lower
light output in case of Silent1,
Silent2 and OFF.
Dynamic Output: fixture will
have variable light output in
order to keep a safe running
temperature.
17