Advertisement
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
MCS--4200/7200 Multi--Channel SATCOM System
3
Line 5
a
This line displays the message ENABLE beginning in column 1 when
the test is not active. The asterisk prompt is displayed and the test
allowed only if the log--on state is Standby. This line displays *DISABLE
<ACTIVE> beginning in column 1 when the test is active. If the log--on
state changes from Standby to any other state while the test is active,
the test is terminated. The commands on lines 4 and 5 are shown only if
the configuration straps indicate this channel is wired for headset use.
b
Pushing LS key 2L when the ENABLE asterisk prompt is shown causes
the voice channel selected to be activated into an analog loopback test
state. Pushing LS key 2L when the DISABLE prompt is shown causes
the voice loopback test state to be terminated.
4
Line 6
a
This line displays MP8E CALL LIGHT TEST beginning in column 2.
Pushing LS key 3L initiates a lamp test of the flight deck channel 1 call
lamp.
5
Line 7
a
This line displays *ENABLE beginning in column 1 when the test is not
active. The asterisk prompt is shown and the test allowed only if the
log--on state is Standby. This line displays *DISABLE <ACTIVE>
beginning in column 1 when the test is active. If the log--on state
changes from Standby to any other state while the test is active, the test
is terminated. The commands on lines 6 and 7 are shown only if the
configuration straps indicate this channel is wired for headset use.
b
Pushing LS key 3L when the ENABLE asterisk prompt is shown causes
the cockpit voice call light to be activated for a steady indication
(regardless of the state of configuration pin TP13C). Pushing LS key 3L
when the DISABLE prompt is displayed causes the cockpit voice call
light test to be terminated.
6
LIne 8
a
This line displays MP2EFGH VOICE LOOPBACK beginning in column
2. Pushing LS key 4L configures the SATCOM system to perform an
audio loopback test of flight deck channel 2.
7
Line 9
a
This line displays ENABLE beginning in column 1 when the test is not
active. The asterisk prompt is shown and the test allowed only if the
log--on state is Standby. This line displays *DISABLE <ACTIVE>
beginning in column 1 when the test is active. If the log--on state
changes from Standby to any other state while the test is active, the test
is terminated. The commands on lines 8 and 9 are displayed only if the
configuration straps indicate this channel is wired for headset use.
Honeywell International Inc. Do not copy without express permission of Honeywell.
23- -20- -35
Page 6--38
15 Jul 2006
Advertisement
