Advertisement
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
MCS--4200/7200 Multi--Channel SATCOM System
Figure 6-5. SATCOM MAINTENANCE Page
5
Access to SATCOM maintenance displays are as follows:
• Push LS key 1L to show the Last Leg Report page (see Figure 6-10)
• Push LS key 2L to show the Previous Leg Report page (see Figure 6-11)
• Push LS key 3Lto show the LRU Identification page (see Figure 6-12)
• Push LS key 5L to show the Trouble Shooting Data page (see
Figure 6-13)
• Push LS key 6L to show the Configuration Data page (see Figure 6-8)
• Push LS key1R to show the Last Leg Class 3 Faults page (see
Figure 6-14)
• Push LS key 2R to show the Test page (see Figure 6-6)
• Push LS key 3R to show the Data Loader Menu page (see Figure 6-9)
• Push LS key 5R to show the Ground Report page (see Figure 6-15).
(b) TEST page
1
If a system-wide functional test (i.e., PAST) is initiated from the SCDU
interface (i.e., by pushing the 2R key on the SATCOM MAINTENANCE
page), the first access of the SATCOM subsystem from an SCDU MAIN
MENU page after the POST/PAST Results Delay period causes the TEST
page to be shown with the status of the current failures. However, the TEST
page shows the TEST IN PROGRESS 60S message if this first access
occurs during the POST/PAST Results Delay period. If the SATCOM
subsystem is not accessed within 5 minutes of the completion of an
SCDU-initiated PAST, the page hierarchy is reset to its original structure as
shown in Figure 6-2.
Honeywell International Inc. Do not copy without express permission of Honeywell.
23- -20- -35
Page 6--34
15 Jul 2006
Advertisement
