Advertisement
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
1. Overview
A. General
(1) Appendix A contains information on vendor-manufactured equipment that can be
installed on an aircraft configured for MCS system. Installation of this equipment
depends on the specific requirements of the operator. Therefore, information in this
section is supplied as a courtesy to the MCS equipment operators.
2. Electronic Cable Specialists
A. General
(1) This paragraph contains information on how to select installation provisions offered
by ECS for the Honeywell MCS--4200/7200 system. ECS designs and manufactures
the installation provisions described here and can supply either individual
components or complete installation kits. The address for Electronic Cable
Specialists is as follows:
Electronic Cable Specialists
5300 W. Franklin Drive
Franklin, WI 53132
U.S.A.
Telephone: (414) 421--5300
FAX: (414) 421--5301
B. Radio Frequency Components
(1) All RF components (cable, connectors, and attenuators) supplied to interface the
SATCOM Avionics and Antenna Subsystems have been designed to meet the strict
usage and attenuation requirements of the Honeywell MCS--4200/7200 system and
ARINC 741/761. A selected list of RF components offered by ECS for SATCOM
installations is shown in Table A--1 and Table A--2.
C. Cable Assembly Fabrication
(1) ECS fabricates cable assemblies guaranteed to meet SATCOM system requirements
and ARINC 741 specifications.
• Each cable assembly is fabricated with an individual part number, which is
permanently affixed to each end of the assembly.
• Each set of cable assemblies is assigned a serial number, which is printed on the
part number label. Serialization makes sure each cable assembly is traceable and
repeatable.
Honeywell International Inc. Do not copy without express permission of Honeywell.
MCS--4200/7200 Multi--Channel SATCOM System
APPENDIX A
VENDOR EQUIPMENT
23- -20- -35
Page A--1
15 Jul 2006
Advertisement
