Step 3: Screw in the body of the weather
proofing gland and tighten
Should it be necessary to disconnect the 30/60 Mbps PIDU to ODU cable at the ODU this can
be achieved by removing the weather proofing gland and depressing the RJ45 locking tab with
a small screwdriver as shown below:
Warning: Ensure that power is removed from the system at the 30/60 Mbps PIDU to prevent
damage to the ODU while making or breaking the connection.
7.7.3
Routing the Cable
After connecting the cable to the ODU it can be routed and secured using standard cable
routing and securing techniques. When the cable is in place it can then be cut to the desired
length at the 30/60 Mbps PIDU prior to connection to the 30/60 Mbps PIDU.
7.7.4
Fitting a Surge Arrestor
If you have opted to fit a Surge Arrestor, this should be installed by following the manufacturer's
instruction. For recommended types see Section 11 "Lightning Protection"
7.7.5
Grounding the Installation
The 30/60 Mbps Backhaul Outdoor Unit (ODU) must be properly grounded to protect against
power surges. It is the user's responsibility to install the equipment in accordance with Section
Issue 3.1, July 2006
Step 4: Screw on the clamping nut and
tighten
Figure 19: Disconnecting the ODU
Page 42 of 162