Figure 30: Vlan Warning Window; Figure 31: Additional Vlan Options - Motorola MOTOwi4 Canopy 30 User Manual

Backhaul
Table of Contents

Advertisement

Gateway IP Address The IP address of a computer / router on the current network that acts as
a gateway. A gateway acts as an entrance / exit to packets from / to other networks.
VLAN High Priority Traffic Threshold If enabled, this sets the 802.1p VLAN user priority
threshold at which bridged traffic will be treated as high-priority.
Use VLAN Management Interfaces If enabled, this allows the use of VLAN For Management
interfaces. Selecting this option, presents the user with extra fields in which to enter the
management VLAN ID, Priority and whether to validate the VLAN ID. The following warning
message window is displayed when this option is enabled:

Figure 30: VLAN Warning Window

After pressing OK, the following VLAN options are added to the LAN Configuration window:

Figure 31: Additional VLAN Options

These parameters control whether the management interfaces (WWW/SNMP/SMTP/SNTP)
use a VLAN. Selecting this option presents the user with extra fields in which to enter the
Management VLAN ID, Priority and whether to validate the VLAN ID.
If communication with the unit is lost due to mis-configuration of the user forgetting the VID that
has been set. The unit can be recovered by resetting the unit to factory defaults as described
in Section 3.1.2 The 30/60 Mbps Power Indoor Unit (PIDU).
Ethernet Configuration This enables the Ethernet configuration to be forced rather than auto
negotiated. The configuration should only be forced if you are having problems with auto
negotiation. You must ensure that you configure both this unit and the Ethernet port to which it
is connected identically. If you force a fixed Ethernet Configuration on the 30/60 Mbps Backhaul
unit then you MUST also force the same fixed configuration on the equipment to which it is
connected. If you fail to force the configuration of the connected equipment, its automatic
configuration mechanisms will normally cause a duplex mismatch, and you will receive greatly
reduced throughput!
Ethernet Auto Mdix This enables/disables the Auto Medium Dependent Interface
(MDI)/Medium Dependent Interface Crossover (MDIX) capability.
Issue 3.1, July 2006
Page 60 of 162

Advertisement

Table of Contents
loading

This manual is also suitable for:

Motowi4 canopy 60

Table of Contents