daviteq WSLRW-AG Series Manual page 3

Lorawan ag tilt angle sensor fw 2

AppEUI

AppKey

Activation Mode

Network Mode

LoraWAN Protocol version

Class

Note: If the above settings do not match your network server/application, please refer to

configuration

to change the settings

Step 2: Register the device on the LoRaWAN network server.

Input the above settings on your device registration page of the network server.

Note: Different network server software will have different device registration processes. Please refer to the

manual of the network server software used for more details.

Please visit

this link

to get the instructions for adding the LoRaWAN sensors to some common network servers such as

Actility, TTN...

Step 3: Install the batteries to the device

Refer to

this link

for details.

After installing the battery in 60 seconds, the first data packet will be sent to the LoRaWAN gateway. After

receiving the first data packet, the time of another packet depends on the value of the parameter:

cycle_send_data. Additionally, you can use a Magnet Key to force the device to send data instantly.

Step 4: Decode the payload of receiving package

Please refer to section

1.4 Uplink Payload and Data Decoding

For the Uplink Payload structure, please refer to

Note: Please select the right Payload document to suit the FW version of the sensor

1.5 Sensor Installation

1.5.1 Dimension drawings

Default value: 010203040506070809

Default value: 0102030405060708090A0B0C0D0E0F10

OTAA with local join server

Public

1.0.3

for details of decoding the receiving packet.

this

link.

section 3.2 Sensor