Table of Contents
Advertisement
POWER OUTPUT WIRING
NOTE
Output relays do not source power. A separate power source must be used when needed. Use the output relay to enable
or disable equipment.
WARNING
ELECTRICAL SHOCK HAZARD! To avoid the risk of electric shock, DO NOT re-connect electrical power until ALL wiring to
the Genesis Heat-Timer
®
CAUTION
Class 2 voltage wiring (low-voltage sensor wires) must use a different enclosure knockout and conduit than any Class 1
voltage wiring.
WIRING THE DOMESTIC HOT WATER CALL DHW
(HOT WATER SYSTEMS ONLY)
•
DHW can be used to raise System Set Point temperature to the DHW Set Point temperature.
DHW with (Priority) or without Priority (Normal) must be selected in the Startup Menu.
See "Domestic Hot Water (DHW) Priority" on page
•
DHW Call terminals are dry contact N.O. terminals.
•
Wire an aquastat or other controls to provide closure on the DHW Call terminals.
•
The DHW function is only available in Hot Water applications.
059705–00 REV. B
control is completed. Failure to do so may result in severe personal injury or death.
(TERMINALS 26, 27)
50.
12
WIRING
DHW Signal
|
27
HEAT-TIMER CORP.
Advertisement
Table of Contents
