Table of Contents
Advertisement
VALVE ACTUATOR
The Genesis Heat-Timer
®
is designed to connect to a motorized valve actuator. Using the inputs from the outdoor temperature
sensor and the system temperature sensor, the Genesis Heat-Timer
motorized valve actuator. The valve can be either a 2-way valve for a steam to water exchanger application or a 3-way mixing valve
for a low temp radiant application or a 2-way valve for a district steam heating application.
For valve actuators requiring a proportional/modulating signal, the Genesis Heat-Timer
configuration the Genesis Heat-Timer
BOILER BURNER
The Genesis Heat-Timer
®
is designed to connect to the boiler burner. Using the inputs from the outdoor temperature sensor and the
system temperature sensor, the Genesis Heat-Timer
BURNER MODULATION
The Genesis Heat-Timer
®
is designed to provide the boiler burner in a hot water application, a current voltage modulation signal.
Using the inputs from the outdoor temperature sensor and the system temperature sensor, the Genesis Heat-Timer
heating system by modulating the boiler burner from 0% to 100%.
SYSTEM
PUMP—HYDRONIC
The System Pump output relay will energize when the outdoor temperature drops below the Outdoor start or whenever the boiler
output is active.
SYSTEM PUMP
(OUTPUT)—STEAM
The system output relay connects to and operates a combustion air-damper or other boiler room equipment and it will energize
whenever there is a call for the boiler.
MODEM
The Genesis Heat-Timer
®
is designed to reset the communication modem. In the event Internet communication has been lost for
more than a hour, the Genesis Heat-Timer
059705–00 REV. B
®
controls the heating system by modulating the valve from 0% to 100%.
®
controls the heating system by turning the boiler burner ON or OFF.
®
will reset the modem power connection by opening the relay contact.
®
controls the heating system by opening and closing the
®
can provide a current voltage signal. In this
06
OUTPUTS
®
controls the
HEAT-TIMER CORP.
|
17
Advertisement
Table of Contents
