Index G220 Operating Instructions And Maintenance Instructions page 7

Preface
Maintenance Instructions
G220
DIE017EN - 05.06.2019
Suitable climbing aids (ladders or steps) may be required to
perform maintenance or service work.
The currently valid safety regulations, as well as the specific
manufacturer's information for the intended use must be
observed.
After all maintenance work and work on electrical assemblies, a test run or
functional test must be performed.
Additionally, the general safety precautions in the operating manual
"Safety instructions for CNC turning machines" must be
observed. The safety precautions, as a separate document, are part
of the INDEX-TRAUB user documentation.
When carrying out maintenance work on fluid systems, (hydraulic,
lubrication, and pneumatic systems), make sure before starting the
work that the respective system has been depressurized.
(accumulator drain valve/manual slide valve/emergency stop)
3