Table of Contents
Advertisement
There are two Paraflow models, which cannot be used together,
according to the bar type and assembly requested for the machinery:
Paraflow tube with 4 in-line atomizers
Paraflow tube with 6 in-line atomizers
μ
ATTENTION! Ceramic nozzles are used for the standard
pneumatic system and the paraflow system. This type of nozzle
has two positions. If the nozzle is fitted so that the flow enters on
the flat side, less flow will be allowed than on the conical side
Hydropneumatic spray system
The hydropneumatic system is medium-high pressure. This system takes
advantage of higher turbulence in the low-volume conical nozzle and
sprays the liquid with an even distribution. The air reaches high speed in
the spout, spraying the liquid in a fan.
There are three spout models with three or five nozzles. These two
models cannot be combined.
E. Spout with 3 nozzles.
F. Spout with 5 nozzles.
Where not all the nozzles are required in treating the crop, the nozzles
can be replaced for caps.
IRIS system
The IRIS application system allows for individual air adjustment as each
outlet permits steep angling or even closing of the air supply, if
necessary.
The IRIS system provides the required droplet size and air conduction to
the target. The most delicate and difficult part of the vine, the grape
cluster, is safely treated throughout the season, due to a very easy and
quick calibration with the IRIS system.
A. Non-drip valve
B. Nozzle
C. Vane position indicator (angle)
D. Air vane adjustment
E. Air vanes
3 - Description
31
Advertisement
Table of Contents
