Mitsubishi Electric MELSEC-Q Series User Manual page 172

10 DEVICES
10 - 14
3) The OUT F
the same instruction.
However, if an anunciator is switched OFF by the OUT F
the "processing at anunciator OFF" (item (b) below) does not occur.
Execute the RST F
been switched OFF by the OUT F
1) To switch OFF only the anunciators stored at SD62 and SD64:
Fault detection program
(Annunciator ON program)
Display reset input
2) To switch OFF all anunciators which are ON:
Fault detection program
(Annunciator ON program)
Display reset input
REMARK
For details regarding the RST and BKRST instruction, refer to the QCPU(Q
mode)/QnACPU Programming Manual(Common Instructions).
instruction can execute ON/OFF of the anunciator No. by
or BKRST instructions after the anunciator has
MOV SD63 Z
SD62 and SD64 annuciators OFF
program
RST F0Z
BKRSTP F0 K10
F0 to F9 OFF program
MELSEC-Q
instruction.
instruction,
10 - 14