Table of Contents
Advertisement
Replacing the power and volume-
buttons board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Slide the power and volume-buttons board into the slot on the computer base
and snap the power and volume-buttons board into place.
2
Adhere the tape that secures the power and volume-buttons board to the
computer base.
3
Route the power and volume-buttons board cable through the routing guide on
the computer base.
4
Connect the power and volume-buttons board cable to the I/O board.
5
Adhere the tape that secures the power and volume-buttons board cable to the
computer base.
Post-requisites
1
Follow the procedure from step 4 to step 7 in
2
Replace the battery.
3
Replace the
base
60
computer. After working inside your computer, follow
After working inside your
cover.
computer. For more safety best
www.dell.com/
"Replacing the hard
Before
drive".
Advertisement
Table of Contents
