Configure Keypad Lock; Set User Code Length; Configure Rental Time (Only In Free Mode); Reset To Factory Values - Ojmar OCS SMART User Manual

4.4.5

CONFIGURE KEYPAD LOCK

With this function active, and the lock closed, entering three incorrect opening codes will
cause the lock to stop working for 30 seconds.
The sequence to activate the keypad lock is as follows:
The sequence to deactivate the keypad lock is as follows:
4.4.6

SET USER CODE LENGTH

The user code can be 4, 5 or 6 digits long.
When the length is set in fixed mode, the code changes to 000000 by default.
The sequence to change the code length to 4 digits is as follows:
The sequence to change the code length to 5 digits is as follows:
The sequence to change the code length to 6 digits is as follows:
4.4.7

CONFIGURE RENTAL TIME (ONLY IN FREE MODE)

The lock can be configured with a maximum rental time after which the lock opens
automatically.
The sequence to set a rental time is as follows:
Where HH: The number of hours. It cannot be set to more than 23 hours.
Where MM: The number of minutes. It can only be set in 15 minute increments; that is, 00,
15, 30 or 45.

NOTE: The maximum rental time is 23 hours and 45 minutes.
The sequence to deactivate the rental time is as follows:
4.4.8

RESET TO FACTORY VALUES

Resetting the lock to factory settings can be done with the lock either open or closed.
The lock reset procedure is as follows:
OCS SMART _ USER MANUAL _ VERSION 1.00
"START" + MASTER CODE + 22 + LOCK
"START" + MASTER CODE + 33 + LOCK
"START" + MASTER CODE + 44 + LOCK
"START" + MASTER CODE + 55 + LOCK
"START" + MASTER CODE + 66 + LOCK
"START" + MASTER CODE + HHMM + 78 + LOCK
"START" + MASTER CODE + 0000 + 78 + LOCK
OJMAR 36