Advertisement
Quick Links
Advertisement
Related Manuals for Ojmar OTS
Summary of Contents for Ojmar OTS
- Page 1 RFID LOCK INSTALLATION AND ASSEMBLY - V1.0 ojmar.com...
- Page 2 INSTALLATION AND ASSEMBLY V1.0 TABLE OF CONTENT 1. GENERAL RECOMMENDATIONS AND INSTRUCTIONS FOR USE ........3 2. OTS LOCK INSTALLATION AND ASSEMBLY ............... 4 3. TECHNICAL DRAWINGS ....................... 5 4. LOCK DIRECTION ......................... 5 5. ASSEMBLY CONSIDERATIONS .................... 6 6. ASSEMBLY AND INSTALLATION PROCESS ................ 7 Pol.
- Page 3 Do not attempt to repair materials after a fault or damage and try to operate it again. In such an event, it is essential you contact us. We take no responsibility for damage caused as the result of misuse. Pol. Ind. Lerun s/n Page 3 of 8 ojmar.com 20870 ELGOIBAR - SPAIN...
- Page 4 INSTALLATION AND ASSEMBLY V1.0 2. OTS LOCK INSTALLATION AND ASSEMBLY The OTS can be installed in lockers up to 20 mm thick. The assembly of the lock in the locker door must be correctly carried out to ensure the correct operation of the lock.
- Page 5 INSTALLATION AND ASSEMBLY V1.0 3. TECHNICAL DRAWINGS RFID LOCK Measurements of OTS lock in mm. 4. LOCK DIRECTION Lock installation must be carried out with screws in four drilled holes. Lock assembly depending on if it is right-handed or left-handed is shown in Figure 1.
- Page 6 (*) NOTE: During installation, ensure that the lock does not collide with the locker body with the door open. The dimensions and location of the fixing holes are shown in the Figure 2. Figure 2. Measurements of OTS lock in mm.
- Page 7 INSTALLATION AND ASSEMBLY V1.0 6. ASSEMBLY AND INSTALLATION PROCESS The steps to follow to assemble an OTS lock on a support or furnishing should be followed in this order: Mark the holes according to Figure 3. Drill the handle hole.
Need help?
Do you have a question about the OTS and is the answer not in the manual?
Questions and answers