Cycle Options - GE Profile DPGT650GH Technical Service Manual

Cycle Options

Note: Not all features are available on all dryer models.
_________________________________________________________________________________________
Lock
You can lock the controls to prevent any
selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start the dryer
by touching pads with this option selected.
Estimated Time Remaining
Displays the approximate time remaining
until the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will "race" in the display. This
means the dryer is continuously monitoring
My Cycles
To save a favorite cycle, set the desired
settings and hold down the MY CYCLES
button for 3 seconds. A beep will sound to
indicate the cycle has been saved.
To use your custom cycle, press the MY
CYCLES button before drying a load.
Wrinkle Care
Tumbles the drum without heat for 10
seconds every 5 minutes for up to 3 hours.
The dryer will display a "racetrack" on the
display during the Wrinkle Care phase.
Wrinkle care shuts off automatically when
the door is opened.
Signal
Alerts you that the cycle is complete.
The clothes should be removed when the
beeper goes off so wrinkles don't set in.
MORE TIME
Increases the dry time in 1-minute
increments, up to 99 minutes.
LESS TIME
Decreases the dry time in 1-minute
increments, down to 10 minutes.
Press SIGNAL to select low or high volume,
or to turn the beeper off.
The beeper will continue to sound every
2 minutes (maximum of 4 times).
To lock the dryer, press and hold the DRY
LEVEL and TEMP buttons at the same time
for 3 seconds. To unlock the dryer, press and
hold the DRY LEVEL and TEMP buttons for
3 seconds.
When the lock function is enabled, CL will
blink in the display with the estimated time
remaining.
the amount of moisture in the load. The lights
will continue until the dryer senses a low level
of moisture in the load. At that point, the
dryer will calculate and display the
approximate time remaining.
To change the saved cycle, set the
desired settings and hold down the MY
CYCLES button for 3 seconds.
– 8 –