AEG DUE731110M User Manual page 4

4 www.aeg.com
Only a qualified person must install this appliance and
•
replace the cable.
Do not use the appliance before installing it in the
•
built-in structure.
Disconnect the appliance from the power supply
•
before carrying out any maintenance.
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
The control panel must be connected to specified
•
heating unit with matching colours of connectors, to
avoid possible hazard.
The means for disconnection must be incorporated in
•
the fixed wiring in accordance with the wiring rules.
WARNING: Ensure that the appliance is switched off
•
before replacing the lamp to avoid the possibility of
electric shock.
WARNING: The appliance and its accessible parts
•
become hot during use. Care should be taken to avoid
touching heating elements or the surface of the
appliance cavity.
Always use oven gloves to remove or insert
•
accessories or ovenware.
To remove the shelf supports first pull the front of the
•
shelf support and then the rear end away from the
side walls. Install the shelf supports in the opposite
sequence.
Do not use a steam cleaner to clean the appliance.
•
Do not use harsh abrasive cleaners or sharp metal
•
scrapers to clean the glass door since they can
scratch the surface, which may result in shattering of
the glass.