AEG DUE731110M User Manual page 28

28 www.aeg.com
• clean the inner door glass with warm
water and soft cloth.
1. Turn on the oven.
2. Press
display shows: "Cata". The cleaning
takes 1 hour.
You cannot change the duration of the
cleaning. You can delay the start of the
cleaning with the function: END.
The signal sounds at the end of cleaning.
The oven turns off.
3. Press any sensor field to stop the
signal.
4. When the oven cools down, clean the
cavity with a wet soft cloth.
Spots or discolouration of the catalytic
coating have no effect on Catalytic
cleaning.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A)
on the two door hinges.
3. Close the door until it is at an angle
of approximately 45°.
again and again until the
A
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
A
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
45°
1