Procedure; Install The Front Coupling - Dentsply Sirona inFire HTC speed Service Manual

10 Upgrading
10.2 Upgrading to non-precious metal sintering
52
2. Unplug the (green & yellow colored) grounding cable.
10.2.4

Procedure

10.2.4.1

Install the front coupling

Mark and punch the front hole
✔
The unit is switched off and its power plug is disconnected.
1. Mark the position of the drill hole on the left side of the front of the
furnace; make it 16 mm from the left edge and 30 mm from the bottom
edge.
2. Center punch the mark.
Drill the front hole
1. Drill a 3 mm pilot hole with a suitable cordless screwdriver or a drilling
machine.
Dentsply Sirona
Service Manual inFire HTC speed
61 30 608 D3497
D3497.076.01.09.02 10.2018