The Cellular Network Screen; The Pin Settings Screen - ZyXEL Communications LTE3202-M430 User Manual

• Use the Antenna Selection screen to configure which antennas the LTE3202-M430 uses
page 40)

6.2 The Cellular Network Screen

Use this screen to change your LTE3202-M430's Internet access settings. Click Configurarion > WAN
network > Cellular Network. The screen appears as shown next.
Figure 18 Configuration > WAN network > Cellular Network
The following table describes the labels in this screen.
Table 13 Configuration > WAN network > Internet Status
LABEL
Cellular Network
Network Type
Roaming
Connection
Control
Apply
Cancel

6.3 The PIN Settings Screen

Use this screen to turn on or turn off PIN code authentication on the inserted SIM card. Click
Configuration > WAN network > PIN Settings. The screen appears as shown next.
Chapter 6 WAN Network
DESCRIPTION
Select the type of the network (4G, 3G, or 2G) to which you want the LTE3202-M430 to connect
and click Apply to save your settings.
Otherwise, select Auto to have the LTE3202-M430 connect to an available network using the
default settings on the SIM card. If the currently registered mobile network is not available or the
mobile network's signal strength is too low, the LTE3202-M430 switches to another available
mobile network.
Select this check box to enable data roaming on the LTE3202-M430.
4G roaming is to use your mobile device in an area which is not covered by your service
provider. Enable roaming to ensure that your LTE3202-M430 is kept connected to the Internet
when you are traveling outside the geographical coverage area of the network to which you
are registered.
Select Auto to connect to the mobile network automatically if there is an available mobile
network. Otherwise, select Manual.
Click Apply to save your changes back to the LTE3202-M430.
Click Cancel to reload the previous configuration for this screen.
LTE3202-M430 User's Guide
35
(Section 6.8 on