Connecting Speakers - JVC UX-H35 Series Instructions Manual

AM antenna
1
2
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the
AM LOOP terminals as illustrated.
2
Turn the AM loop antenna until you
have the best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it
horizontally. The AM loop antenna must remain
connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the power cord.
7
Vinyl-covered wire
(not supplied)

Connecting Speakers

1
Speaker cord
Right speaker
1
Press and hold the clamp of the
speaker terminal on the rear of the
unit.
2
Insert the end of the speaker cord into
the terminal.
Match the polarity between the unit and the
speaker terminals: ª to ª and · to ·.
3
Release your finger from the clamp.
• DO NOT connect speakers while the
power is on.
• DO NOT connect more than one speaker
to each speaker teminal.
IMPORTANT: Use only speakers with the same
speaker impedance as shown on the speaker
terminals on the rear of the unit.
2
Speaker cord
Left speaker