Connecting Speakers - JVC MX-J300 Service Manual

AM antenna
1 2
ANTENNA
FM
FM
75
AM
EXT
AM LOOP
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
2
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
loop antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
3
Vinyl-covered wire
(not supplied)
GND
GND

Connecting Speakers

You can connect a pair of the front speakers.
1
Speaker
cord
Right
speaker
1
Press and hold the clamp of the speaker
terminal on the rear of the unit.
2
Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
3
Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
– 9 –
2 3
Red
CAUTION:
SPEAKER IMPEDANCE
6~16 OHMS
SPEAKERS
Speaker
RIGHT LEFT
cord
Black
Left
speaker