Digital Connections - JVC XL-R5000BKB Instructions Manual

Digital Connections

Before proceeding, check whether the optical
digital cable can be connected.
• Connect a receiver or amplifier with digital audio capability to
the DIGITAL OPTICAL connectors on this unit.
• One connecting cable is used to transmit the stereo signals (L/
R) as a digital signal.
DIGITAL IN
OPTICAL
DIGITAL OUT
OPTICAL
LINE
IN REC ( ) OUT PLAY ( )
LEFT LEFT
RIGHT RIGHT
To DIGITAL
OUT OPTICAL
connector
To OPTICAL INPUT connector
Receiver or amplifier with
digital OPTICAL connector
CD player, etc.
To OPTICAL OUTPUT connector
Optional optical digital cable
VOLTAGE SELECTOR
Optional
optical digital
cable
• If analog audio connections are also being made, try to use the
digital connectors on the receiver or amplifier that are labeled
the same way as the analog connectors.
• Before purchasing an optical digital cable (optional), make sure
that the cable in question can be connected to the amplifier, etc.
• Do not bend the optical digital cable at a sharp angle.
• When the power is turned on, the inside of the connector lights
up red. This light is for sending the digital signals. Although
this light will not harm your eyes, keep the protective cap in
place if the connector is not going to be used.
COMPU LINK - 4
(SYNCHRO)
MODE
CDR TD
Units have a voltage selector excluding units for
Canada, Europe, and U.S.A.
How to use the OPTICAL connectors for the
connections
1
Remove the protective cap.
• When the connector is not going to be used, fit this protective
cap back in position.
2
Check that the end of the optical digital cable is
not dirty, and insert it securely.
XL-R5000 CD/CDR MULTIPLE
COMPACT DISC RECORDER
4