To Check Plumb; Safety Precaution - ADA INSTRUMENTS TOPLINER 3-360 GREEN Operating Manual

10
English

TO CHECK PLUMB

Choose a wall and set laser 5 m away from the wall. Hang a plumb with the
length 2.5 m on the wall. Turn on the laser and make the vertical laser line
meet the point of the plumb. The accuracy of the line is in the range if the
vertical line doesn't exceed (up or down) the accuracy that is shown in the
specifications (e.g. ±3 mm/10 m). If the accuracy isn't corresponding with
claimed accuracy, contact the authorized service center.
APPLICATION
This cross line laser level generates visible laser beam allowing to make the
following measurements:
Height measurement, calibration of horizontal and vertical planes, right an-
gles, vertical position of installations, etc. The cross line laser level is used for
indoor performance to set zero marks, for marking out of bracing, installation
of tingles, panel guides,tiling, etc. Laser device is often used for marking out
in the process of furniture, shelf or mirror installation, etc. Laser device may
be jsed for outdoor performance at distance within its operation range.

SAFETY PRECAUTION

• Caution label regarding laser class must be placed near emitter.
• Do not look at the laser beam.
• Do noi install the laser beam at the eye level.
• Do not try to disassemble the instrument. In the case of failure, the
instrument will be repaired only in authorized facilities.
• The instrument meets laser emission standard.