Connecting The Speakers - JVC RX-E51BEB Instructions Manual

Connecting the speakers

Speaker Layout Diagram
Left surround
speaker (LS)
2
1
Connecting the front, center, and surround speakers
Turn off all components before making connections.
1
Twist and remove the insulation at the end of each
speaker cord.
2
Press and hold the clamp of the speaker terminal
(1), then insert the speaker cord (2).
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
3
Release the finger from the clamp.
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
6
Left front
speaker (L)
Center speaker (C)
3
1
2
SW
Right front
speaker (R)
2(VIDEO) 1(DVR/DVD)
FRONT
RIGHT
DIGITAL IN
SUBWOOFER
OUT
R L
Connecting the subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord
with RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or a subwoofer, set the
speaker setting information properly to obtain the best possible
surround effect. For details, see pages 14 to 17.
NOTE
You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
Subwoofer (SW)
Right surround
speaker (RS)
CAUTION: SPEAKER
IMPEDANCE 6 ~ 16
CENTER SURROUND
SPEAKERS
LEFT RIGHT LEFT
C RS LS