Tuner Operations; Tuning In To Stations Manually; Using Preset Tuning - JVC RX-E51BEB Instructions Manual

Tuner operations

Tuner operations are mainly done from the remote control.
When you have selected "FM" or "AM" by using SOURCE
SELECTOR on the front panel, press FM/AM on the remote
control to use the remote control for tuner operations.
When operating the receiver using the remote control,
set the mode selector to "AUDIO/TV/VCR/STB."

Tuning in to stations manually

From the remote control ONLY:
1
Press FM/AM to select the band.
The last received station of the selected band is tuned in.
• Each time you press the button, the band alternates
between FM and AM (MW).
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS
LPCM L C R PL
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
2
Press repeatedly or hold TUNING 9 or
( TUNING until the station you want is tuned
in.
• Pressing (or holding) TUNING 9 increases the frequency.
• Pressing (or holding) ( TUNING decreases the frequency.
NOTES
• When you hold and release TUNING 9 or ( TUNING, the
frequency keeps changing until a station is tuned in.
• When a station of sufficient signal strength is tuned in, the
TUNED indicator lights up on the display.
• When an FM stereo program is received, the ST (stereo)
indicator also lights up.

Using preset tuning

Once a station is assigned a channel number, the station can be
quickly tuned simply by selecting the number. You can preset up to
30 FM and 15 AM (MW) stations.
To store the preset stations
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
From the remote control ONLY:
1
Tune in to the station you want to preset (see
"Tuning in to stations manually" above).
• If you want to store the FM reception mode for this station,
select the FM reception mode you want. See "Selecting the
FM reception mode" on page 24.
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS
LPCM L C R PL
DOLBY D NEO : 6
S . WFR
LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
2
Press MEMORY.
The channel number position starts flashing on the display for
about 5 seconds.
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS
LPCM L C R PL
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
CONTINUED ON THE NEXT PAGE
TUNED ST AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
TUNED ST AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
TUNED ST AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
23