JVC RX-E51BEB Instructions Manual page 12

For TV and video format
This receiver cannot convert the video signals. When the video
signal of one video component is different from that of the other
(for example, one is S-video, the other is Composite), you may
not see the pictures appropriately. In this case, unify the video
signals of all the video components, or you need to switch the
video signal of TV each time you change the source.
For an analogue decoder
To watch through or to record a scrambled program on your
VCR, connect the analogue decoder to your VCR and select
the scrambled channel on your VCR.
If there is not an appropriate terminal for the decoder
connection on your VCR, connect the decoder to your TV.
Refer also to the manuals supplied with these components.
For T-V LINK
• You can use the T-V LINK function if you connect a T-V LINK
compatible TV and VCR to this receiver with a fully wired
SCART cables. For details on T-V LINK, refer also to the
manuals supplied with the TV and the VCR.
• Connect a SCART cable to EXT-2 terminal on the JVC's T-V
LINK compatible TV for the T-V LINK function.
• Some video components support the data communication
like T-V LINK. For complete details, refer also to the manuals
supplied with these components.
Audio/video connection
In addition to the SCART terminals, this receiver is equipped with
the following video terminals:
• Component video input/output: DVR/DVD IN, MONITOR OUT
• Composite video input: VIDEO IN
NOTE
When recording the sounds and pictures onto the DVD recorder
or VCR, record them through the SCART terminals.
IMPORTANT
The component video signals from the COMPONENT VIDEO
jacks are transmitted only through the MONITOR OUT jacks.
Therefore, if the TV is connected to the receiver through the
SCART terminal (TV) and a playing video component is
connected to the receiver through the component video jacks
(DVR/DVD IN), you cannot view the playback picture on the TV.
8
7 Connecting a DVD recorder or DVD player to the
DVR/DVD IN jacks
To fully enjoy Dolby Digital and DTS multi-channel software (including
Dual Mono software), connect the DVD recorder or DVD player
through the digital input/output terminals (see page 9).
AUDIO
Y
MONITOR
OUT
DVR/DVD
IN
VIDEO
Red White
Green
Stereo audio
cable
Å ı
(not supplied)
DVD recorder or DVD player
Å To left/right audio channel output
ı To component video output
NOTES
• Connect Y, P , and P correctly.
B R
• Do not connect different components to the AUDIO DVR/DVD
IN jacks and AV IN/OUT DVR/DVD terminal; otherwise, sounds
from both components are come out of the speakers at the
same time.
7 Connecting a TV to the MONITOR OUT jacks
AUDIO
MONITOR
OUT
Red White
Green
Stereo audio
cable
Å
(not supplied)
Å To left/right audio channel input
ı To component video input
NOTES
• Audio signals come out through the AUDIO MONITOR OUT
(RIGHT/LEFT) jacks when TV Direct is in use (see page 12).
• Connect Y, P , and P correctly.
B R
VIDEO
VIDEO IN
P P
B R
VIDEO
COMPONENT
Red
Blue
Component video
cable (not supplied)
VIDEO
Y P P
B R
Red
Blue
Component
video cable
ı
(not supplied)
TV