Table of Contents
Advertisement
11
Troubleshooting
11.1 Communicating with the QuickServer Over the Network
•
Confirm that the network cabling is correct.
•
Confirm that the computer network card is operational and correctly configured.
•
Confirm that there is an Ethernet adapter installed in the PC's Device Manager List, and that it is configured to run the
TCP/IP protocol.
•
Check that the IP netmask of the PC matches the QuickServer. The Default IP Address of the QuickServer is
192.168.2.X, Subnet Mask is 255.255.255.0.
◦ Go to Start|Run
◦ Type in "ipconfig"
◦ The account settings should be displayed
◦ Ensure that the IP Address is 102.168.2.X and the netmask 255.255.255.0
•
Ensure that the PC and QuickServer are on the same IP Network, or assign a Static IP Address to the PC on the
192.168.2.X network.
42
QuickServer FS-QS-1XXX Start-up Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the QuickServer FS-QS-1 Series and is the answer not in the manual?