Rep 5.0 Separator O-Ring Adjustments For Different Media - Xerox Versant 4100 Press Manual

Customized envelope feeder

Hide thumbs Also See for Versant 4100 Press:

Table of Contents

REP 5.0 Separator O-Ring Adjustments for Different Media

Overview

Advance the Separator Assembly O-Rings when they show wear. Follow the steps below to access the

O-Rings on the Separator:

Turn the power switch to the Off position and remove the Feeder power cord from the

power source.

Move the Feeder away from the Versant Bypass Tray.

Engage the J-Hook to lock the Discharge Assembly of the Feeder in the UP position.

Remove the Separator Assembly from the Separator Bracket by pushing down on the

Separator Barrel while lifting up on the Separator Adjustment Knob (Repeat this process

when re-installing the Separator Assembly onto the Separator Bracket).

Move the O-Ring assemblies along the shaft to change the O-Ring orientation on the

Nudger.

NOTE: As an alternative, you can use a screwdriver to separate the O-rings without removing the

Separator Assembly. BE SURE THE UNIT IS POWERED OFF.

4-16

Xerox Customized Envelope Feeder – Problem Solving Guide

Table of Contents