Xerox Versant 4100 Press Manual page 14

Occasionally, the envelope substrate/material is either too smooth or t0o rough, and multifeeds
still occur even at the lowest setting for the separator. In such instances, you may need to move the
O-ring assemblies in the Separator to a position where they are partially or completely over the belts
instead of the defualt position in the middle of the belts.
NOTE: Models A, B, and C have the default position of the O-ring assembly in between the belts. Model D
has the default position of the O-ring assemblies directly on top of the belts.
Follow the steps below to access the O-Rings on the Separator
1. Turn the power switch to the Off position and remove the Feeder power cord from the power source.
2. Move the Feeder away from the Versant Bypass Tray.
3. Engage the J-Hook to lock the Discharge Assembly of the Feeder in the UP position.
4. Remove the Separator Assembly from the Separator Bracket by pushing down on the Separator
Barrel while lifting up on the Separator Adjustment Knob (see below)
5. Move the O-Ring assemblies along the shaft to change the O-Ring orientation on the Nudger.
(See next page for sample settings of O-rings)
As an alternative, you can use a screwdriver to separate the O‐rings without removing the Separator Assembly.
Insert a flat‐head screwdriver in between the two O‐ring assemblies and twist the screwdriver
**BE SURE THE UNIT IS POWERED OFF / UNPLUGGED WHEN
PERFORMING THIS PROCEDURE **
3-4 Xerox Customized Envelope Feeder – Problem Solving Guide