Rep 4.8 Separator Adjustment Procedure - Xerox Versant 4100 Press Manual

REP 4.8 Separator Adjustment Procedure

Overview
The gate assembly pre-shingles the product to help the feed belts move one piece of product
at a time based on the gap between the gate assembly and the feed belts. Pre-shingling helps
the gate to efficiently separate and single-out the product. The gap between the gate and the
feed belts is adjustable to accommodate different product thicknesses.
The discharge belts are located under the hold down assembly.
Combined with the hold down assembly, the discharge belts provide the friction necessary to
pull the piece of product away from the gate assembly, resulting in a gap between each piece
of product as it leaves the gate assembly area.
The Separator is a removable friction retard assembly in the center of the feeder that enables the
feeder to "peel off" an envelope from the bottom of the stack when the belts move (see below).
Xerox Customized Envelope Feeder – Problem Solving Guide
O‐rings
4-13