Powering On And Off; Powering On In Operating Mode; Powering On In Standby Mode; Powering Off - Lectrosonics duet DCHT Instruction Manual

Powering On and Off

Powering On in Operating Mode

Press and hold the Power Button
until the progress bar on the LCD finishes.
When you release the button, the unit will be operational
with the RF output turned on and the Main Window dis-
played. You can also use the programming switch if it is
configured for this function.
DCHT
Hold
for
MUTE
Rf On
470.100
-40

Powering On in Standby Mode

A brief press of the power button
before the progress bar finishes, will turn the unit on
with the RF output turned off. In this Standby Mode the
menus can be browsed to make settings and adjust-
ments without the risk of interfering with other wireless
systems nearby.
Release
Hold
Power Button
for before the bar
progresses to
Rf On
enter Standby
Mode
NOTE: After settings and adjustments are made,
press the power button again to turn the unit off
or navigate to menu item Xmit, RFOn? to choose
to begin transmitting.

Powering Off

To turn the unit off, press and hold
hold the Power Button
Powering
seconds and wait for the progress bar
O ...
to finish, or use the programmable
switch (if it is configured for this
function).
If the power button is released, or
the top panel switch is turned back on again before the
progress bar finishes, the unit will remain turned on and
the LCD will return to the same screen or menu that was
displayed previously.
NOTE: If the programmable switch is in the OFF
position, power can still be turned on with the
power button.
Rio Rancho, NM
for a few seconds
-20 +0
, and releasing it
RF indicator blinks
DCHT
470.100
-40 -20 +0
for a few
Main Menu and Setup
Screen Details

Entering the Main Menu

The LCD and keypad interface makes it easy to browse
the menus and make the selections for the setup you
need. When the unit is powered up in either the operating
or the standby mode, press MENU/SEL on the keypad
to enter a menu structure on the LCD. Use the
arrow buttons to select the menu item. Then press the
MENU/SEL button to enter the setup screen.
Input...
Gain
Rolloff
StMode
The prompt in the upper right corner may
display one or both arrows, depending upon
what adjustment can be made. If the changes
are locked, a small padlock symbol will appear.

Main Window Indicators

The Main Window displays the current settings, status,
audio level and battery status.
Programmable
Switch Function DCHT
MUTE
470.100
Frequency (MHz)
-40
Audio level
If the programmable switch function is set for MUTE, the
Main Window will indicate that the function is enabled.
DCHT
Mute function
enabled but
MUTE
not active
470.100
-40
When the switch is turned on, the mute icon appearance
will change and the word MUTE will blink at the bottom
of the display. The -10 LED on the top panel will also
glow solid red.
Mute function
DCHT
enabled and active
MUTE
470.100
<–MUTE–>
Digital Transmitter
Gain
25
-40 -20 0
Operating
mode
(Transmit or
Standby)
Battery status
-20 +0
-20
+0
Main Window will
blink the word
MUTE when the
audio is muted
and
7