SANY SY500H Operation And Maintenance Manual page 124

MAINTENANCE
7. Close the drain valve when the oil has completely
drained from the engine.
8. Install the machine's bottom cover.
NOTICE!
Dispose of used oil in accordance with all
applicable environmental regulations. Failure to
do so could damage the environment.
Figure 5-16
9. Locate the engine oil filter (6) behind the right rear
door. See "Right Rear Access Door" on page 4-8.
10. Place a container under the engine oil filter.
11. Remove the oil filter using a suitable filter wrench.
12. Clean the engine oil filter mount (5).
13. Clean the oil filter mounting surface.
14. Coat the new filter seal ring with a thin layer of
engine oil.
15. Fill the new filter with clean engine oil.
16. Thread the new filter into place on its mount until the
filter gasket touches the filter mount, then tighten the
filter by hand an additional 3/4 of a turn.
17. Remove the engine oil filler cap.
NOTE: Do not overfill the engine with oil. Overfilling of oil
could result in machine damage or improper
machine operation.
18. Add oil as needed. See "Location, Capacity, and
Type" on page 5-6 for engine capacity.
5
6
0004773
7 7
19. Install the engine oil filler cap (7).
20. Remove the dipstick (8) from the engine and note the
oil level.
9
NOTE: The oil level should be within the etched area (9)
of the dipstick.
21. If the oil is below the etched area, remove the engine
oil filler cap, then add engine oil until the oil level is
within the etched area.
22. Install the oil filler cap.
23. Start and run the engine at idle speed while checking
for oil leaks.
24. Shut down the engine, wait several minutes, then
remove the dipstick from the engine and note the oil
level.
25. If necessary, remove the oil filler cap, add oil as
needed, then install the filler cap.
5-16
Figure 5-17
8
Figure 5-18
Figure 5-19
SY500H Excavator OMM
0004775
0004772
0000736