Summary of Contents for Sun Microsystems Sun Blade 2000
Page 1
Template used to position the card guide Installing the Card Guide and Template To install the card guide into your Sun Blade 2000 system, you must do the following: 1. Shut down and power off your system. 2. Remove the system cover.
Page 2
4. Remove the template from the package included with this document, which looks similar to the following. 5. Place the template into the Sun Blade 2000 system, which looks similar to the following. third fan guide template Note – Place the template so that the middle square of the template fits into the third fan guide from the right.
Page 3
9. Install the SunPCi III card into your Sun Blade 2000 system. Refer to the SunPCi III Quick Start Installation Guide (817-0358-10) for specific information about installing a SunPCi III card and the Sun Blade 1000 and Sun Blade 2000 Service Manual (816-3217-10) for specific information about a Sun Blade 2000.
Page 4
Copyright 2003 Sun Microsystems, Inc. All rights reserved. Use is subject to license terms. Third-party software, including font technology, is copyrighted and licensed from Sun suppliers. Portions may be derived from Berkeley BSD systems, licensed from U. of CA. Sun, Sun Microsystems, the Sun logo, and Solaris are trademarks or registered trademarks of Sun Microsystems, Inc. in the U.S.
Need help?
Do you have a question about the Sun Blade 2000 and is the answer not in the manual?
Questions and answers