Table of Contents
Advertisement
3
3.7
EXIT FROM THE SETUP PROCEDURE
To end the SETUP procedure, you will have to:
1 - Select the Exit menu by pressing [ESC]
2 - Select one of the items by pressing the correct key (an erroneous one re-enters
the setup procedure):
KEY
Press [S] to activate
the function.
Press [C] to activate
the function.
Press [Q] to activate
the function.
Press [D] to activate
the function.
-
If you exit with saving, a message appears notifying that the program is about to
quit, and you can choose to reboot the Formula Color™ terminal to see the
effects of the new configuration. Remember that the Formula Color™ terminal
parameters are used by BIOS at boot-time.
-
If you exit with the "Discard" command, no change will affect CMOS and
EEPROM memories.
-
If you choose the "factory parameters", the application applies it and then re-
enters the setup procedure.
20
DESCRIPTION
Saves the new values in the CMOS
memory and EEPROM memory and
exits.
Saves the new values in the CMOS
memory and exits.
Discards the new values and exits.
Load the default factory values.
FORMULA COLOR™
ITEM
CMOS+EEPROM
Save & Exit
CMOS Save & Exit
Discard
Factory parameters
Advertisement
Table of Contents
