Table of Contents
Advertisement
Section 2 – Product Overview
2.1 – Introduction
Thank you and congratulations on the purchase of your new TI150 Series Battery Charger/Conditioner.
This manual contains the complete operating instructions and procedures for the TI150 Series Battery
Charger/Conditioner models: TI15014-120 and TI15028-120. The TI150 Battery Charger/Conditioner
has been designed to rapidly recharge any 12 or 24 volt battery, depending on the model. Both models
incorporate an intelligent recharging circuit that prevents overcharging and provides pure dc output for
efficient battery charging and conditioning.
The TI150 Battery Charger/Conditioner is encased in a rugged enclosure, and is designed to be mounted
to a vehicle or other fixed object using the integrated mounting base. Both models include a detachable
line cord and two interchangeable dc output cables (ring terminals for direct battery connection or alligator
clamps for rapid connect and disconnect. See Figure 2.1.1). Each model's capabilities and requirements
are listed below:
• Model TI15014-120 accepts 120 Vac and charges 12V batteries
• Model TI15028-120 accepts 240 Vac and charges 12V batteries
• Model TI15014-240 accepts 120 Vac and charges 24V batteries
• Model TI15028-240 accepts 240 Vac and charges 24V batteries
2.2 – Indication of Terms: Shall, Should, and May
Within this technical manual the word "shall" is used to indicate a mandatory requirement for proper
operation and warranty purposes. The word "should" is used to indicate a non-mandatory but preferred
method of accomplishment. The word "may" is used to indicate an acceptable method of accomplishment.
TI150 Series Hardwired Battery Charger/Conditioner
Figure 2.1.1 – TI150 Series Battery Charger/Conditioner
3
Advertisement
Table of Contents
